notea said: id suggest updating the bios and chipset drivers and then try again. i think the Aorus RGB rams werent released yet when the Z370 UG was launched, so updating the bios and chipset drivers should theoretically solve your problem. I had updated chipset drivers from the gigabyte website and the latest 16a bios. So as the title says, Iā€™m having difficulty in getting the RGB colored fans to sync with the motherboard. The fans are working, just the color isnā€™t syncing and itā€™s flashing red and not allowing me to change it. The fans came with the case (Thermaltake Versa J24 RGB) and thereā€™s an RGB controller on the back that also came with the case. One sec. Shut down -> flick led switch on motherboard to off -> boot up -> enter desktop -> open mystic light -> set rgb off (or make change)-> turn off PC -> turn off power supply -> unplug power cord for couple minutes -> flick led switch on mobo to on -> plug power cable back in -> turn on PSU -> boot up PC and it should be fixed. Not sure MSI Z490 Unify - JRAINBOW1/2 not working. Hi there, Just finished a build with this motherboard and having issues with the 5v addressable header - they do not work - no life at all. Iā€™m using an EK AIO 360 drgb cooler. Included is a 3pin drgb connector. And 3x 120 drgb Vardar S fans. This really isn't that big of a deal in the long run, but its mostly for my ease of mind. " Shut down -> flick led switch on motherboard to off -> boot up -> enter desktop -> open mystic light -> set rgb off (or make change)-> turn off PC -> turn off power supply -> unplug power cord for couple minutes -> flick led switch on mobo to on -> plug Controlling RGB Hub wie Mystic Light. Today I build a new PC using a MSI Velox 100R case. The case has a build-in ARGB Hub and a dedicated button for switching between lighting modes. The hub is also connected to the JRAINBOW2 header on the mainboard. I connected the 4 system fans, the case LEDs and the AiO fans and waterblock with the RGb hub. First, see if there is an RGB FW update in LiveUpdate. If so, if that update works it might restore it. THe last time Dragon Center was bricking RGB Controller, the reps over on the official MSI forums were able to provide a manual flashing tool. It required them to bridge a jumper on their board while it was running to work, but that may be an 1. 1,535. Jan 25, 2023. #1. Reaching out simply because majority of the cases relating to this issue go unsolved. I currently am using both iCUE and MSI Center to control my RGB and I only need MSI for the memory cards RAM and motherboard, but the mystic light feature comes and goes and my lighting settings reset almost daily on my motherboard. I installed the latest Mystic Light and my Adata XPG DT41 RAM (2x8 Gb 3600CL17) is not seen by the latest mystic light. I tried installing ML version 3.0.0.64 and 63, they see the ram,. but don't change the color in any way. I want to sync the ram with my mobo with one software, of the motherboard, and usually the MBs detects my ram, but not in Disable RGB Lights using your systemā€™s physical switch (if your system has one). Now save your changes and restart your system. Upon restart, power off your system and then power it on to boot into the BIOS of your system. Now, enable RGB and restart your system. Upon restart, check if MSI Mystic Light is working fine. DWEsCDQ.